Nanjing Qianjin Sheet Metal Co., Ltd

Qianjin sheet metal company was found in 1989 and we have 2 factories and more than 110 people in each factory over 20 years development.

Home > News > Content
Methods And Precautions Of Exterior Design In Sheet Metal Equipment-2
- Feb 07, 2019 -

Secondly, due to the material processing properties caused by the modeling constraints, in the industrial sheet metal equipment design process, designers will generally apply the following methods. Firstly, Mondrian cutting techniques, the use of this technique in the design is very extensive. This requires designers in the plane composition of the need for a certain amount of power. Secondly, the laminated method, in the laminated approach, we have to use in combination with the Mondrian method. The product looks breathable and has a stereoscopic sense through laminated processing.

Thirdly, the slant cutting splicing technique, this method through the face of the oblique clipped, often this practice will let the product appear exaggerated characteristics.

Furthermore, the color collocation of sheet metal equipment design is also an important factor for designers. In fact, sheet metal color collocation and medical Products color Collocation method is a bit close. Generally speaking, the product is not more than three colors. Perhaps sheet metal products are more thinner, almost the product is only one color to embellish, in particular, the black and white color is not counted. And in the sheet metal color collocation when the designer should use less large area of the method, and the medical belt color is generally low-purity use, industrial equipment is generally low purity and low brightness application.

In particular, this refers to the majority, because it can also be paired with light color, and sometimes this collocation will be very good. In addition, for medical device sheet metal equipment, to truly reflect the characteristics of the flexible hardware of medical devices, must rely on sheet metal process, so medical devices on the sheet metal process requirements are relatively high, which is reflected in the precision requirements of the active connector, especially after the welding splicing connector, the outer frame of the surface appearance process requirements, special appearance molding, welding and grinding consistency; surface treatment requirements, in addition to internal connectors have galvanized or blackened treatment, generally using electrostatic spraying or paint (currently gradually replaced by the former), the requirements of uniform and soft color, strong bonding force, no defects on the surface, and color mainly to light tone-based. All of these need to be considered during the actual sheet metal equipment modeling design.